Stránka 1 z 1
Audi A4 2007 panel RB8 chyba DO 3-3
Napsal: úte lis 28, 2017 21:52 pm
od podivoc
Nemate nekdo skusenost s opravou problemu?chyba se objevila jen po precteni commanderem,vsechno bez zavad akorat immostatus 0. Auto ma bloknuty immo...
Diky P.
Napsal: úte lis 28, 2017 23:03 pm
od exotus
NOTE: When reading the RB8 EEPROM the device is put into service mode and “L0 x-y”
is
displayed. If by any reason the instrument leaves in this situation (e.g. if your laptop
goes
off due flat battery, or you disconnect the interface from the car, or the car battery is flat),
you need to read the RB8 instrument EEPROM, and change the immobilizer status to 6.
Napsal: úte lis 28, 2017 23:20 pm
od podivoc
Napsal: stř lis 29, 2017 13:42 pm
od podivoc
jj prepsanej immostatus to vyresil dik za info
